EGR Monitor Repair Verification Drive Cycle
- Refer to and complete the Vehicle Application Preparation For OBD-II Drive Cycle in this section before initiating the following repair verification steps. See VEHICLE CHECK/PREPARATION .
- Start the engine and drive the vehicle for 24 minutes.
- Drive in stop-and-go traffic for 19 minutes with at least four idle periods.
- Accelerate to 40 MPH (64 km/h) at more than 1/2 throttle. Maintain speed for 1 minute. Maintain speed for one minute.
- Accelerate on highway to 55 MPH (89 km/h). Maintain speed for 4 minutes.
- Repeat quick test. See QUICK TEST .