LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1997 >> Probe Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Module Communications Network System) >> Communication Network Diagnostics >> Retrieving Parameter Identification (PID) Information
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Retrieving Parameter Identification (PID) Information

WARNING: This page is about a different car, the 1997 Mercury Grand Marquis and 1997 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This procedure may be used to verify operation of input cir-cuitry for selected module being tested.
  1. Connect New Generation Star (NGS) scan tester on Data Link Connector (DLC) and perform proper hook-up procedure. See EQUIPMENT HOOK-UP .
    NOTE: If instructed to retrieve PID from a specified test procedure, ensure ignition switch is in proper position as listed in test procedure.
  2. Turn ignition switch to RUN position unless otherwise instructed by specified test procedure. Rotate dial on scan tester to DIAGNOSTIC DATA LINK menu and press trigger.
  3. Rotate dial on scan tester to highlight the desired module you wish to access and press trigger. Rotate dial on scan tester to PID/DATA MONITOR AND RECORD and press trigger.
  4. Rotate dial on scan tester to highlight the PID acronyms you wish to view and press trigger. Repeat this procedure until all desired PIDs are selected. When all PID acronyms have been selected, press button No. 7 to view all selected PIDs.
scientia non olet · About LEMON Manuals