LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1997 >> Probe GTS, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Module Communications Network) >> Testing >> Test K: Driver's Door Module (DDM) Does Not Respond To Scan Tester
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test K: Driver's Door Module (DDM) Does Not Respond To Scan Tester

WARNING: This page is about a different car, the 1997 Lincoln Continental. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure ignition switch is in OFF position. Disconnect 84-pin harness connector C217. Harness connector C217 is located behind driver's side of instrument panel. See Figure .
  2. Using ohmmeter, check resistance between terminal No. 76 (Tan/Orange wire) on male side of harness connector C217 and terminal No. 2 (Tan/Orange wire) on Data Link Connector (DLC). See Figure and Figure .
  3. If resistance is 5 ohms or less, go to next step. If resistance is more than 5 ohms, repair open circuit on Tan/Orange wire between DLC and harness connector C217. Repeat TEST A  .
  4. Using ohmmeter, check resistance between terminal No. 77 (Pink/Light Blue wire) on male side of harness connector C217 and terminal No. 10 (Pink/Light Blue wire) on DLC. See Figure and Figure .
  5. If resistance is 5 ohms or less, go to next step. If resistance is more than 5 ohms, repair open circuit on Pink/Light Blue wire between DLC and harness connector C217. Repeat TEST A  .
  6. Disconnect 16-pin connector C523 from Driver's Door Module (DDM). The DDM is located inside the driver's door. See Figure .
  7. Using ohmmeter, check resistance between terminal No. 76 (Tan/Orange wire) on female side of harness connector C217 and terminal No. 6 (Tan/Orange wire) on connector C523. See Figure and Fig 1 .
  8. If resistance is 5 ohms or less, go to next step. If resistance is more than 5 ohms, repair open circuit on Tan/Orange wire between harness connector C217 and connector C523. Repeat TEST A  .
  9. Using ohmmeter, check resistance between terminal No. 77 (Pink/Light Blue wire) on female side of harness connector C217 and terminal No. 5 (Pink/Light Blue wire) on connector C523. See Figure and Fig 1 .
  10. If resistance is 5 ohms or less, replace DDM. Repeat TEST A  . If resistance is more than 5 ohms, repair open circuit on Pink/Light Blue wire between harness connector C217 and connector 523. Repeat TEST A  .
Fig 1: Identifying Connector C523 Terminals
G97H28776Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals