Engine Controls - System/Component Tests - WINDSTAR: Introduction

Before testing separate components or systems, perform BASIC DIAGNOSTIC PROCEDURES in BASIC TESTING article. Since many computer-controlled and monitored components set a Diagnostic Trouble Code (DTC) if they malfunction, also perform SELF-DIAGNOSTICS in TESTS W/CODES - EEC-V article.

NOTE: Testing individual components does not isolate short or open circuits. Perform all voltage tests with a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm input impedance, unless stated otherwise in test procedure. Use ohmmeter to isolate shorted or open wiring harness.

NOTE: For identification of circuits and terminals referenced in test procedures, see appropriate article:

For 3.0L, see WIRING DIAGRAMS - 3.0L.
For 3.8L, see WIRING DIAGRAMS - 3.8L.