Remote Climate Control Assembly

REMOVAL
1. Remove integrated control panel.
2. Open glove compartment, press sides inward and lower glove compartment to floor.
3. Remove two screws retaining remote climate control module to A/C evaporator housing.
4. Remove two vacuum harness retaining nuts, and disconnect wiring connector and vacuum hose harness from remote climate control module and remove module from vehicle.

INSTALLATION
1. Position remote climate control module near A/C electronic blend door actuator. Connect wiring connector and vacuum hose harness to remote climate control module.
2. Install remote climate control module to A/C evaporator housing with two retaining screws.
3. Install integrated control panel.