Switch Knobs

REMOVAL
1. Rotate knob to straight up-and-down position, grasp knob and pull rearward.

NOTE: Do not pry the knob off its shaft. Damage to the surface of the integrated control panel may result.

2. If the D-shaped spring clip which sits inside the back end of knob remains on shaft when knob is pulled off, remove it with needlenose pliers and install on knob.
3. To install knob, align its keyed surface with mating surface on shaft, rotate to straight up-and-down position and press knob forward until fully seated in control shaft.

INSTALLATION
1. Follow removal procedure in reverse order.