Continuous Memory Self-Test: Description

Continuous memory self-test is a functional test of PCM performed under any condition (engine running or off) with ignition switch turned to ON position. Unlike KOEO and KOER self-tests which can only be activated on demand, continuous monitor is always active in monitoring the system. When a fault is detected, DTC will be stored in memory. This makes it possible to diagnose intermittent faults.

There are 2 types of Continuous Memory DTCs. Emission related type DTCs will turn on the Malfunction Indicator Light (MIL) on instrument cluster. Non-emission type DTCs will never turn on MIL. On emission related MIL codes, PCM will store DTC in continuous memory at first detection of fault. The MIL will not be illuminated and DTC is reported as a pending DTC. If same fault is detected in next drive cycle, MIL will be illuminated. MIL will go out if 3 consecutive drive cycles have been run. An emission related pending DTC or non-emission DTC will be erased after 40-80 warm-up cycles or PCM reset.