Transaxle Shift Quality Quick Learn Procedure
WARNING: This page does not describe the selected car, but rather 120 other vehicles, including the 2002 Saturn Vue, 2002 Saturn SL2, 2002 Saturn SL1, 2002 Saturn SL, and 2002 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.
This program allows the electronic transaxles system to recalibrate itself. This will provide the best possible transaxle operation.
- Transaxle shift quality quick learn procedure must be performed to provide proper transaxle operation if any of the following have been done:
- Transaxle assembly was replaced.
- Transmission Control Module (TCM) was replaced.
- Solenoid/pressure switch assembly was replaced.
- Clutch plate and/or seal replaced.
- Valve body was reconditioned or replaced.
- Transaxle shift quality quick learn procedure must be performed using Chrysler's Diagnostic Readout Box (DRBIII®) scan tool. Following conditions must be met when performing transaxle shift quality quick learn procedure:
- Brakes must be applied.
- Engine speed must be greater than 500 RPM.
- Throttle position sensor angle must be less than 3 degrees.
- Shift lever must remain in designated position until prompted to shift to overdrive.
- Shift lever must remain in overdrive after the shift to overdrive until scan tool indicates procedure is complete.
- Calculated oil temperature must be 60-200°F (16-93°C).
- Connect scan tool to Data Link Connector (DLC) below driver's side of instrument panel. Go to TRANSMISSION display on scan tool.
- Go to MISCELLANEOUS display on scan tool. Select QUICK LEARN PROCEDURE display on scan tool. Follow instructions displayed on scan tool to perform transaxle shift quality quick learn procedure.