LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2000 >> Contour SVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1089 (Fuel System & Engine Control System) >> Removal And Installation >> Fuel Pump Driver Module (FPDM) >> Removal and Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .

    2. Five Hundred 

  2. Remove the rear seat cushion and the rear corner backrest. For additional information, refer to SEATING .

    3. Freestyle 

  3. Remove the C-pillar trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .

    4. All vehicles 

  4. Disconnect the fuel pump driver module (FPDM) electrical connector.
  5. Remove the 2 nuts and the FPDM.
    • To install, tighten to 5 Nm (44 lb-in).
  6. To install reverse the removal procedure.
scientia non olet · About LEMON Manuals