Inspection and Verification
WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- Verify the customer concern.
- Visually inspect for obvious signs of electrical damage.VISUAL INSPECTION CHART
Electrical - Battery junction box (BJB) fuse(s):
- 2 (30A)
- 5 (40A)
- 10 (30A)
- 15 (15A)
- 18 (20A)
- 29 (60A)
- Central junction box (CJB) fuse(s):
- 1 (30A)
- 15 (5A)
- 16 (5A)
- 19 (10A)
- 20 (5A)
- 21 (5A)
- 22 (10A)
- 24 (15A)
- 25 (5A)
- 26 (7.5A)
- 30 (5A)
- Wiring harness
- Connections
- Battery junction box (BJB) fuse(s):
- If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
- If the cause is not visually evident, connect the diagnostic tool to the data link connector (DLC) and select the vehicle to be tested from the diagnostic tool menu. If the diagnostic tool does not communicate with the vehicle:
- check that the program card is correctly installed.
- check the connections to the vehicle.
- check the ignition switch position.
- If the diagnostic tool still does not communicate with the vehicle, refer to the diagnostic tool operating manual.
- GO to PINPOINT TEST PC .
- If the diagnostic trouble code(s) (DTCs) retrieved are related to the concern, go to the COMMUNICATIONS NETWORK DIAGNOSTIC TROUBLE CODE (DTC) INDEX .
- If no DTCs related to the concern are retrieved, GO to SYMPTOM CHART .