Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
Remove the front brake disc. For additional information, refer to FRONT DISC BRAKE .
Disconnect the wheel speed sensor electrical connector.
Remove the 3 wheel speed sensor harness retainers.
Remove the 2 wheel speed sensor harness pin-type retainers.
Remove the wheel speed sensor bolt.
- To install, tighten to 17 Nm (13 lb-ft).
Remove the wheel speed sensor and the harness.
To install, reverse the removal procedure.