Removal and Installation
WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Prior to removal of the DSM, it is necessary to upload module configuration information to a diagnostic tool. This information needs to be downloaded into the new module once installed. For additional information, refer to MODULE CONFIGURATION
.
- Remove the driver seat. For additional information, refer to SEATING .
- Remove the 2 DSM screws.
- Disconnect the electrical connectors and remove the DSM.
- To install, reverse the removal procedure.
NOTE:
Once the module is installed, it is necessary to download the module configuration information from the diagnostic tool into the new module. For additional information, refer to MODULE CONFIGURATION
.