Removal and Installation
WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Prior to removal of the vehicle security module, it is necessary to upload module configuration information to a diagnostic tool. This information needs to be downloaded into the new module once installed. For additional information, refer to MODULE CONFIGURATION
.
- Remove the RH rear quarter trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
- Disconnect the 3 vehicle security module electrical connectors.
- Remove the 3 vehicle security module screws.
- Remove the vehicle security module.
- To install, reverse the removal procedure.
NOTE:
Once the module is installed, it is necessary to download the module configuration information from the diagnostic tool into the new module. For additional information, refer to MODULE CONFIGURATION
.