Inspection and Verification
WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If a module is installed it must be reconfigured. Refer to MODULE CONFIGURATION
.
- Verify the customer concern by operating the vehicle to duplicate the condition.
- Verify the stoplamps operate correctly by applying and releasing the brake pedal with the ignition switch in the OFF position. If the stoplamps do not operate correctly, refer to EXTERIOR LIGHTING . If the stoplamps operate correctly, proceed to the next step.
- Verify that the PRNDL operates correctly on the instrument cluster. If the PRNDL does not operate correctly, refer to INSTRUMENT CLUSTER . If the PRNDL operates correctly, proceed to the next step.
- Inspect to determine if any of the following mechanical or electrical concerns apply.VISUAL INSPECTION CHART
Mechanical Electrical - Wheel speed sensor ring
- Hydraulic control unit (HCU)
- Incorrectly inflated tires
- Mismatched wheels or tires on vehicle
- Base brake concern
- Brake booster vacuum hose
- Ford-specified steering components, suspension components and tire size
- Steering wheel rotation ring
- Auxiliary battery junction box (AJB) fuse(s):
- 14 (30A)
- 22 (40A)
- ABS module
- EVAC and fill connector
- Wheel speed sensor
- Advance Trac®/IVD switch
- PTS switch
- Steering wheel rotation sensor
- Brake booster solenoid
- Brake booster release switch
- Brake pressure transducer
- Yaw rate sensor (integral to sensor cluster)
- Accelerometer (integral to sensor cluster)
- Wiring harness
- Connectors or connections
- Circuitry
- If the concern remains after the inspection, connect the diagnostic tool to the data link connector (DLC) located beneath the instrument panel and select the vehicle to be tested from the diagnostic tool menu. If the diagnostic tool does not communicate with the vehicle:
- check that the program card is correctly installed.
- check the connection of the data link connector to the vehicle.
- check that the ignition switch is in the RUN position.
- If the diagnostic tool still does not communicate with the vehicle, refer to the diagnostic tool manual.
- Carry out the diagnostic tool data link test. If diagnostic tool responds with:
- SCP or ISO; all electronic control units, no response/not equipped, refer to MODULE COMMUNICATIONS NETWORK .
- No response/not equipped for the ABS module, GO to PINPOINT TEST A .
- System passed, retrieve and record the continuous DTCs, clear the continuous DTCs, cycle the ignition switch OFF and ON, then carry out the self-test diagnostics for the ABS module.
- If the DTCs retrieved are related to the concern, go to ANTI-LOCK BRAKE SYSTEM (ABS) (WITH OR WITHOUT ADVANCE TRAC®/IVD) MODULE DIAGNOSTIC TROUBLE CODE (DTC) INDEX to continue diagnosis.
- If no DTCs related to the concern are retrieved, GO to SYMPTOM CHART to continue diagnosis.