LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2000 >> Contour SVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1355 (Front Disc Brake System) >> Removal And Installation >> Front Brake Caliper >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Brake Caliper: Installation

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Make sure guide pin boots are correctly seated or damage to guide pins can occur.
    NOTE: Tighten the lower brake caliper bolt first.
  1. Install the brake caliper to the anchor plate and install the 2 brake caliper bolts.
    • Tighten to 36 Nm (27 lb-ft).
  2. Using 2 new copper washers, position the brake hose and install the brake caliper flow bolt.
    • Tighten to 48 Nm (35 lb-ft).
  3. Bleed the brake system. For additional information, refer to BRAKE SYSTEM-GENERAL INFORMATION .
  4. If the vehicle is equipped with air suspension, reactivate the system by turning on the air suspension switch.
  5. Fill the brake master cylinder reservoir with brake fluid. Install the brake master cylinder filler cap.
  6. Apply the brake pedal several times before driving the vehicle.
    • Test the brake system for normal operation.
    7. WARNING: If equipped with fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM .
  7. If equipped with fire suppression system, repower the system.
  8. If equipped, turn the air suspension service switch to the ON position.
scientia non olet · About LEMON Manuals