Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the instrument panel center finish panel. For additional information, refer to REMOVAL AND INSTALLATION .
- Remove the temperature selector gear knob.
- Remove the temperature selector gear screw.
- Press the tab and rotate the temperature selector gear counterclockwise.
- Remove the temperature selector gear.
- To install, reverse the removal procedure.
- Place the temperature selector switch in the full cold position before installation.
NOTE:
Place the temperature selector switch in the full cold position before disengaging the temperature blend door actuator.