Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Electronic modules are sensitive to electrical charges. The ABS module can be damaged if exposed to these charges.
CAUTION:
Do not allow any brake fluid or foreign material to enter the mating side of the ABS module or damage to the solenoids can occur.
- Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
- Remove the degas bottle. For additional information, refer to ENGINE COOLING .
- Disconnect the anti-lock brake system (ABS) module electrical connector.
- Remove the 3 ABS module screws and the ABS module.
- To install, tighten to 2 Nm (18 lb-in).
- To install, reverse the removal procedure.
NOTE:
Visually inspect the ABS module terminals for damage before installation.