Electronic Automatic Temperature Control (EATC) and Dual Automatic Temperature Control (DATC) Module - Diagnostic Methods: Notes
WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
The electronic automatic temperature control (EATC) and dual automatic temperature control (DATC) system must be diagnosed by first retrieving any DTCs, if present.
- An on-demand (hard fault) DTC indicates that the fault is currently present. An on-demand DTC suggests a wiring fault, disconnected connector or component failure.
- A continuous (intermittent) DTC alone (corresponding on-demand DTC is not present) indicates that the fault is an intermittent condition and may not be currently present. A continuous only DTC suggests a poor wiring connection, loose pin or terminal or intermittent component failure.
On-demand (hard fault) or continuous (intermittent fault) DTCs can be retrieved using a scan tool. If using a scan tool, refer to the scan tool operating manual.
On-demand DTCs can also be retrieved by carrying out the EATC AND DATC MODULE ON-DEMAND SELF TEST . To retrieve and/or clear continuous DTCs, carry out the DATC/EATC MODULE - RETRIEVE CONTINUOUS DTCS procedure. Always carry out the EATC AND DATC MODULE ON-DEMAND SELF TEST before retrieving continuous DTCs.
If no DTCs are present, GO to SYMPTOM CHART for the appropriate diagnostic action.