Throttle Position (TP) Sensor: Installation
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
- Position the new TP sensor and install the 2 new screws.
- Tighten to 3 Nm (27 lb-in).
- Connect the TP sensor electrical connector.
CAUTION:
Do not use a high-speed driver to install the new screws or damage to the throttle position (TP) sensor may occur.
NOTE:
Do not reuse the TP sensor and screws. A new TP sensor and screws must be installed.
NOTE:
When installing the new TP sensor, make sure that the radial locator tab on the TP sensor is aligned with the radial locator hole on the throttle body.