LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2000 >> Contour SVT >> Repair and Diagnosis >> Steering >> Steering Columns >> Removal & Installation >> Contact Assembly (CLOCKSPRING) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Contact Assembly (CLOCKSPRING): Installation

  1. Center new contact assembly before installation. See Figure and Figure . Hold contact in hand and rotate inner rotor against outer rotor counterclockwise until it stops. Rotate inner rotor clockwise about 2 3/4 turns until alignment marks are aligned and locking tab is in slot.
  2. Install new contact assembly. Ensure retaining tangs lock into position. Remove locking tab. If reinstalling original contact, remove tape after installing. Connect contact assembly wire connector into column harness. Install upper and lower shrouds.
  3. Install steering wheel. Connect contact assembly wire connector into terminal on air bag module. Install air bag module. Connect battery cables. Check AIR BAG light for system faults.
scientia non olet · About LEMON Manuals