General Inspection (All Models)
- Inspect clutch pressure plate diaphragm fingers for wear. Inspect clutch plate for oil or grease saturation, worn or loose facings, warpage, loose rivets at hub and broken springs. Also, inspect for wear or rust on splines.
- Check rear main seal for leakage. Inspect pressure plate for burn marks, scores, flatness and ridges. Install NEW clutch plate on transmission input shaft, and ensure clutch plate slides freely.
- Rotate outer race of clutch release hub while applying pressure. If bearing rotation is rough, replace clutch release hub and bearing. Check for worn or damaged clutch release hub and bearing fork contact surfaces. Check for any surface scoring or burrs inhibiting sliding motion of clutch release bearing on hub.
CAUTION:
Clutch release bearing is prelubed and should not be cleaned with solvent. Clutch release hub and bearing are replaced as an assembly. DO NOT disassemble for inspection or replacement.