Cylinder Block
WARNING: This page is about a different car, the 2001 Ford ZX2 and 2000 Ford ZX2. However, it is still accessible from the selected car via links, so may be relevant.
- Using a feeler gauge and straightedge, inspect cylinder block deck surface for warpage. If not within specification, resurface or replace cylinder block. See CYLINDER BLOCK table under ENGINE SPECIFICATIONS. DO NOT remove more than .010" (.25 mm) material from block deck.
- Measure cylinder bore out-of-round and taper. If out-of-round or taper exceeds specification, rebore cylinder for oversize piston. See CYLINDER BLOCK table. If cylinder bore is okay, lightly hone cylinder to a cross-hatch pattern.