Key Programming - Erase All Keys & Program 2 Keys
NOTE:
This procedure is used when a customer needs keys programmed into system after original keys are lost or stolen and does not have 2 programmed ignition keys available, or when ignition switch assembly has been replaced. This procedure will erase all programmed ignition keys from Passive Anti-Theft System (PATS) control module memory, and prevent vehicle from starting until 2 keys have been programmed. Ignition keys must have correct mechanical key cut for vehicle and must be an encoded key. If additional key(s) are to be programmed, perform KEY PROGRAMMING - WITH PROGRAMMED KEYS
. If remaining keys are with customer and not with vehicle, instruct customer to see owner's manual to program spare key(s).
- Insert Ford Service Function (FSF) card VERSION 1.0 or higher into scan tool. Turn ignition switch from LOCK to RUN position. Select SERVICE BAY FUNCTIONS, then PATS. Perform KEY PROGRAMMING - SECURITY ACCESS PROCEDURE . After security access procedure has been completed, a new menu will be displayed with command options. Select IGNITION KEY CODE ERASE.
- Turn ignition switch to LOCK position. Disconnect scan tool. Insert first encoded ignition key into ignition switch. Turn ignition switch to RUN position for 3 seconds. Turn ignition switch to LOCK position. Remove first encoded key.
- Within 5 seconds, insert second encoded ignition key into ignition switch. Turn ignition switch to RUN position for 3 seconds. Turn ignition switch to LOCK position. Remove second encoded key. Both encoded ignition keys should now start vehicle. Try new keys to ensure vehicle starts.