Rear Power Window Motor: Removal
- Lower window glass until it is half down. Remove door trim panel and trim shield. Remove side impact bolster. Remove 4 screws securing door speaker and disconnect wire connector (if equipped). Detach door latch release handle. Cut through Butyl strip securing watershield to door and peel back watershield. Connect window control switch and align window regulator clamp with access hole.
- Push out pin, then sleeve from regulator clamp and remove window glass from window regulator. Secure window glass in UP position. Disconnect window control switch and window motor harness connectors. Remove 3 screws securing window regulator. Remove window regulator and window motor assembly.