LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2000 >> Mustang Base, 2D Convertible, Automatic >> Repair and Diagnosis (Single Page) >> Brakes >> Traction Control >> Anti-Lock Brake System >> Symptom Tests >> No Communication With Abs Control Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

No Communication With Abs Control Module

  1. Turn ignition off. Disconnect 30-pin ABS control module connector. Turn ignition on. Using DVOM, measure voltage between ABS control module connector terminal No. 8 (Light Blue/Pink wire) and ground. See WIRING DIAGRAMS . If voltage is greater than 10 volts, go to next step. If voltage is less than 10 volts, replace fuse No. 29 (15-amp) located in instrument panel fuse block, and/or repair Light Blue/Pink wire between ABS control module and instrument panel fuse block.
  2. Turn ignition off. Using DVOM, measure resistance between ABS control module connector terminal No. 15 (Black/White wire) and ground. Also measure resistance between ABS control module connector terminal No. 12 (Black wire) and ground. See WIRING DIAGRAMS . If resistance is less than 5 ohms, replace ABS control module. Repeat self-test. If resistance is greater than 5 ohms, repair Black and/or Black/White wire between ABS control module and ground connection.
scientia non olet · About LEMON Manuals