Security Access Procedure

NOTE: Security access is used to erase ignition keys, enable/disable spare key programming switch or perform parameter resets for Passive Anti-Theft System (PATS) transceiver module. This procedure has a 10 minute time delay prior to security access.

Connect New Generation Star (NGS) tester to Data Link Connector (DLC). Turn ignition switch to RUN position. Enter Powertrain Control Module (PCM). Select SECURITY ACCESS PROCEDURE. After 10 minute time delay, NGS tester will display command options. Select as many functions as required before exiting menu. Once menu is exited, security access procedure must be performed again for additional commands.