LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2000 >> ZX2 Automatic >> Repair and Diagnosis >> Electrical >> Starter >> Starting System >> On-Vehicle Testing >> Starter Ground Circuit Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Starter Ground Circuit Test

NOTE: Make all voltmeter connections at component terminal rather than at cable or wire end.
  1. Disconnect low voltage wires at coil pack to prevent vehicle from starting during testing. Connect remote starter switch between starter solenoid terminal "S" and positive battery post.
  2. Connect positive voltmeter lead to starter housing, and negative lead to negative battery post. Engage remote starter switch while observing voltmeter. Voltmeter should indicate .2 volt or less. If voltmeter indicates more than .2 volt, clean negative cable connections at battery and engine.
  3. If voltage drop is still excessive, repair or replace negative battery cable and/or engine ground cable as necessary. Repeat starter circuit test after repair to ensure problem has been corrected. If battery and cables test okay and starter motor still cranks slowly, replace starter. See STARTER MOTOR  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals