Cooling System Flushing
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
Material
| Item | Specification |
|---|---|
| Premium Cooling System Flush VC-1 |
ESR-M14P7-A |
WARNING:
Always allow the engine to cool before opening the cooling system. Do not unscrew the coolant pressure relief cap when the engine is operating or the cooling system is hot. The cooling system is under pressure; steam and hot liquid can come out forcefully when the cap is loosened slightly. Failure to follow these instructions may result in serious personal injury.
- Drain the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding .
- Remove the coolant thermostat. For additional information, refer to Thermostat .
- Install the coolant hose connection without the coolant thermostat.
- Using the an appropriate cooling system flusher, flush the engine and radiator.
Use Premium Cooling System Flush VC-1 meeting Ford specification ESR-M14P7-A. Always flush the cooling system with water thoroughly after using the VC-1 flush and prior to filling the cooling system. Always fill the cooling system with the same coolant that was present in the system. Do not mix coolant types.
- Install the coolant thermostat. For additional information, refer to Thermostat .
- Backflush the heater core. For additional information, refer to Heater Core Backflushing .
- Fill and bleed the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding .
NOTE:
Refer to the cooling system flusher manufacturer's operating instructions for specific vehicle hook-up.