De-initialization procedure
WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
- Turn the ignition key ON.
- Operate the window control switch in one-touch mode and remove power from the window motor while the window is moving
by one of the following methods:
- Disconnect the vehicle battery cable while the window is moving.
- Disconnect the window motor connector while the window is moving.
- Remove the LH front window motor fuse while the window is moving.
- This will de-initialize the window motor and reset the window motor to its original factory settings.
- Perform the initialization procedure to turn the one-touch-up feature on.
Initialization procedure
NOTE: The LH front window must be in the full open position for this procedure to operate correctly. - Turn the ignition key ON.
- Activate and hold the window control switch in the up position at the second detent until the window glass stalls for 2 seconds into the glass top run and release the switch.
- Activate and hold the window control switch in the down position at the second detent until the window glass stalls for 2 seconds at the bottom of its travel and release the switch.
- Test for correct window operation by carrying out the one-touch-up and one-touch-down features.
NOTE:
The LH front window motor must be reset to its original factory settings first, then perform the following de-initialization procedure.