Removal and Installation
WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the speed control deactivator switch electrical connector.
- Remove the speed control deactivator switch.
- Rotate the speed control deactivator switch counterclockwise 45 degrees and remove the deactivator switch.
- To install, reverse the removal procedure.
CAUTION:
Do not press the brake pedal when removing or installing the speed control deactivator switch, as the switch will be damaged.
NOTE:
When installing the speed control deactivator switch it is automatically self-adjusting to the proper position. Do not pull up on the pedal or push down on the pedal during installation. Initial installation of the speed control deactivator switch allows for one adjustment. If additional adjustments are necessary, install a new switch.