LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2000 >> ZX2 Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1475 (Cruise Control System) >> Diagnosis And Testing >> Speed Control >> Inspection and Verification >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection and Verification: Notes

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: If equipped with fire suppression system, refer to FIRE SUPPRESSION SYSTEM for important safety warnings.
  1. Verify the customer concern.
  2. Visually inspect the following for obvious signs of mechanical or electrical damage.
    VISUAL INSPECTION CHART

    Mechanical Electrical
    • Throttle body
    • Central junction box (CJB) fuse 5 (10A)
    • Circuitry
    • Stoplamp switch
    • Speed control deactivator switch
    • Powertrain control module (PCM)
    • Speed control switches
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
  4. Verify the stoplamps operate correctly with the ignition switch in the OFF position. If the stoplamps do not operate correctly, refer to EXTERIOR LIGHTING .
  5. If the cause is not visually evident, connect the diagnostic tool to the data link connector (DLC) and select the vehicle to be tested from the diagnostic tool menu. If the diagnostic tool does not communicate with the vehicle:
    • check that the program card is correctly installed.
    • check the connections to the vehicle.
    • check the ignition switch position.
  6. If the diagnostic tool still does not communicate with the vehicle, refer to the diagnostic tool operating manual.
  7. Carry out the diagnostic tool data link test. If the diagnostic tool responds with:
    • CAN circuits fault; all electronic control units no response/not equipped, refer to MODULE COMMUNICATIONS NETWORK .
    • No response/not equipped for PCM, refer to MODULE COMMUNICATIONS NETWORK .
    • System passed, retrieve and record the continuous diagnostic trouble codes (DTCs), erase the continuous DTCs, and carry out the self-test diagnostics for the PCM.
  8. If the DTCs retrieved are related to the concern, go to the POWERTRAIN CONTROL MODULE (PCM) DIAGNOSTIC TROUBLE CODE (DTC) INDEX .
  9. If no DTCs related to the concern are retrieved, GO to SYMPTOM CHART .