Section 596 (Suspension System)
WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Description And Operation
- Diagnosis And Testing
- Wheels And Tires
- Tire Pressure Monitoring System
- Notes
- Special Tool(s)
- Principles of Operation
- Inspection and Verification
- Tire Pressure Monitor System (TPMS) Module Diagnostic Trouble Code (DTC) Index
- Symptom Chart
- Connector Reference and Terminal Readings
- Pinpoint Tests
- Pinpoint Test A: No Communication With The TPMS Module/Unable To Enter Self-Test
- Pinpoint Test B: TPMS Will Not Enter Sensor Training Mode
- Pinpoint Test C: Message Center Displays "TIRE PRESSURE MONITOR FAULT"
- Pinpoint Test D: DTC B2849 - Horn Output Relay Circuit Open
- Pinpoint Test E: DTC B2872 - Tire Pressure Sensor Fault
- Pinpoint Test F: Message Center Displays "CHECK TIRE PRESSURE" or "TIRE VERY LOW" and/or the TPMS Indicator On Continuously
- Sensor Training
- Suspension System
- General Procedures
- Removal And Installation
- Ball Joint - Lower, 2WD
- Ball Joint - Lower, 4WD
- Wheel and Tire - Front
- Wheel Bearing, Hub, Knuckle, Upper Arm and Lower Arm - Front
- Special Tool(s)
- Removal and Installation
- Notes
- Item 1: Axle-to-Wheel Hub Nut Removal Note
- Item 2: Speed Sensor Harness Removal Note
- Item 5: Brake Caliper, Pads and Anchor Plate Removal Note
- Item 10: Tie-Rod End-to-Wheel Knuckle Nut Removal Note
- Item 11: Lower Ball Joint-to-Wheel knuckle Nut Removal Note
- Item 12: Upper Ball Joint-to-Wheel Knuckle Nut Removal Note
- Item 27: Lower Arm Installation Note
- Item 24: Lower Arm-to-Frame Nut (forward mounting) Installation Note
- Item 21: Shock Absorber-to-Lower Arm Bolt Installation Note
- Item 16: Upper Arm Installation Note
- Item 13: Wheel Knuckle Installation Note
- Shock Absorber and Spring Assembly - Front
- Stabilizer Bar and Link - Front
- Wheel and Tire - Rear
- Special Tool(s)
- Removal and Installation
- Notes
- Item 2: Wheel Nuts Removal Note
- Item 5: Caliper, Pads and Anchor Plate Removal Note
- Item 9: Access Hole Knockout Removal Note
- Item 10: Wheel Stud Removal Note
- Item 10: Wheel Stud Installation Note
- Item 9: Access Hole Knockout Installation Note
- Item 3: Wheel and Tire Installation Note
- Item 2: Wheel Nuts Installation Note
- Wheel Bearing, Hub, Knuckle, Upper Arm and Lower Arm - Rear
- Shock Absorber and Spring Assembly - Rear
- Stabilizer Bar and Link - Rear
- Tire Pressure Sensor
- Tire Pressure Monitoring System Module
- Disassembly And Assembly