Ignition Timing: Villager
WARNING: This page is about a different variant/trim than selected.
- Ensure engine is at operating temperature, all accessories are off, and transmission is in Park or Neutral. Set parking brake. Rev engine to 2000-3000 RPM 2 or 3 times and allow engine to return to idle. Turn engine off. Disconnect TPS connector. Start engine and rev to 2000-3000 RPM 2 or 3 times and allow engine to return to idle. Ensure idle speed is correct. Idle speed should be 700-800 RPM in Park or Neutral.
- Connect timing light to No. 1 spark plug wire. Check base ignition timing. See Fig 1. See IGNITION TIMING table.
- If timing is not to specification, loosen distributor hold-down bolt. Adjust timing as necessary. Turn engine off. Reconnect TPS harness connector.
IGNITION TIMING
| Application | Degrees BTDC | ||
|---|---|---|---|
| Except Villager | 8-12 | ||
| Villager | (1) 13-17 | ||
|
|||