Pinpoint Test PC: Data Link Diagnostics Test

WARNING: This page is about a different car, the 2005 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

PC1 DATA LINK DIAGNOSTICS TEST
- Key in ON position.
- Enter the following diagnostic mode on the diagnostic tool: Diagnostic Tool Data Link Test.
- Is system passed obtained?
- Yes : The test passed. RETURN to the Symptom Chart of the section for the module in question.
- No : If high speed controller area network (CAN) circuit faults; all electronic control units no response/not equipped, GO to PINPOINT TEST G .
  If medium speed CAN circuit faults; all electronic control units no response/not equipped, GO to PINPOINT TEST H .
  
  If international standards organization (ISO) 9141 communications network circuit fault; all electronic control units no response/not equipped, GO to PINPOINT TEST I .
  
  If no response from the diagnostic tool, GO to PINPOINT TEST J .
  
  If the module in question is no response/not equipped, GO to SYMPTOM CHART .