Keyless Entry Keypad
NOTE:
Factory code is printed on owner's wallet card, located in glove compartment and on Generic Electronic Module (GEM).
NOTE:
System only allows one personal code to be programmed. Any existing personal code will not need to be erased to program a new one.
- Enter permanent factory keyless entry keypad code. Press 1/2 button within five seconds to activate programming mode. Holding 1/2 button for more than two seconds after activation will erase the stored personal code.
- Within five seconds, enter new five-digit keyless entry keypad code. Power door locks will lock and unlock to confirm new code is programmed.