Remote Transmitter
NOTE:
When programing remote transmitters, all transmitters MUST BE programmed at the same time(maximum of 4 original and/or new transmitters). Failure to program all transmitters at the same time will render all other transmitters inoperative.
NOTE:
Factory code is printed on owner's wallet card, located in glove compartment and on Generic Electronic Module (GEM).
- Insert a key in ignition switch and turn from LOCK to RUN position 8 times in rapid succession (within 10 seconds) ending in RUN position. Doors will lock/unlock to confirm that programming mode has been entered.
- Within 20 seconds, program a remote transmitter by pressing any button on a transmitter. Doors will lock/unlock to confirm that remote transmitter has been programmed. (If more than 20 seconds pass before pressing a remote transmitter button, programming mode will exit and procedure will have to be repeated).
- Repeat previous step to program additional remote transmitters. Doors will lock/unlock to confirm that each remote transmitter has been programmed.
- After remote transmitters have been programmed, turn ignition switch to LOCK position or wait 20 seconds. Again, doors will lock/unlock to confirm programming has been completed.