Power Mirror Control Switch
Remove power mirror control switch. See POWER MIRROR CONTROL SWITCH under REMOVAL & INSTALLATION. While operating switch in specified position, measure resistance between power mirror control switch connector C527 terminals. See POWER MIRROR CONTROL SWITCH TEST table. See Fig 1 . Resistance in all tests should be less than 5 ohms. If switch fails any portion of test, replace switch.
POWER MIRROR CONTROL SWITCH TEST
| Switch Position(1) | Measure Between Terminals No. | |||
|---|---|---|---|---|
| Left Mirror | ||||
| Up | 1 & 6; 5 & 7 | |||
| Down | 1 & 7; 5 & 6 | |||
| Left | 1 & 6; 4 & 5 | |||
| Right | 1 & 4; 5 & 6 | |||
| Right Mirror | ||||
| Up | 1 & 6; 5 & 8 | |||
| Down | 1 & 8; 5 & 6 | |||
| Left | 1 & 6; 3 & 5 | |||
| Right | 1 & 3; 5 & 6 | |||
|
||||