Remote Transmitter Without Icons
NOTE:
Remote Keyless Entry (RKE) system program connector is a 2-pin Data Link Connector (DLC) located below driver's side of instrument panel, at base of steering column and may be referred to as RKE DLC.
- Turn ignition switch to RUN or ACC position. Using shorting pin, short RKE DLC terminals together. All doors should lock, then unlock.
- Press any button on a remote transmitter. All doors should lock, then unlock to verify transmitter has been programmed. If doors do not respond, press button again (3 times maximum) with same transmitter. If doors still do not respond, go to TEST A: ALL DOOR LOCKS INOPERATIVE under SYSTEM TESTS.
- Repeat procedure for additional transmitters (4 maximum). Turn ignition switch to OFF position. Remove shorting pin from RKE DLC. Verify remote transmitters have been programmed by depressing LOCK and UNLOCK buttons and vehicle responds accordingly.