Remote Keyless Entry Transmitter
NOTE:
All remote keyless entry (RKE) transmitters MUST be programmed at the same time.
To program (or reprogram) RKE transmitters into Vehicle Security Module (VSM), perform the following steps:
- Turn ignition switch to OFF, then to RUN positions 8 times within 10 seconds, ending in RUN position. If VSM has successfully entered program mode, it will lock and unlock all doors.
- Press any button on remote keyless entry transmitter, and doors will lock, and unlock to confirm remote transmitter has been programmed. Repeat procedure with additional remote transmitters.
- If door locks do not respond for any remote keyless entry transmitter, wait for several seconds, press button again.
- Turn ignition off, or wait 5 minutes after step 1, to exit program mode. If a remote transmitter has been programmed (or reprogrammed), the VSM will lock and unlock all doors one last time.