LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2002 >> Excursion 7.3 F, 4WD >> Repair and Diagnosis >> General Information >> Computer Relearn Procedures >> Ford Motor Co. >> Rear Ride Height Initializing Procedure (BLACKWOOD Only) >> Calibration Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Calibration Procedure

NOTE: DO NOT save original rear ride heights. Air suspension module has pre-calibrated values already stored.

Turn ignition off and then on. Exit vehicle, close all doors and allow system to vent vehicle down to kneel height (about 30 seconds). Connect NGS tester to Data Link Connector (DLC). Using NGS tester, select AIR SUSPENSION MODULE. Select "Save Calibration Values (Store Ride Height)" from scan tool menu to calibrate air suspension module. Press "Trigger" to by-pass warning message(s) and save "Initialization". Press "Trigger" to toggle from OFF to ON.

scientia non olet · About LEMON Manuals