Gearshift Cables: Installation

WARNING: This page is about a different car, the 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: When inserting the gearshift cables through the dash panel, make sure the arrow on the grommet is pointing down.

Insert the gearshift cables through the dash panel.

Fig 1: Gearshift Cables Through Dash Panel

Courtesy of FORD MOTOR CO.

Connect the select cable.

Fig 2: Select Cable

Courtesy of FORD MOTOR CO.

Connect the gearshift cable.

Fig 3: Gearshift Cable

Courtesy of FORD MOTOR CO.

Install the 2 gearshift cable grommet nuts.
- Tighten to 10 Nm (89 lb-in).

CAUTION: Make sure the clips are set completely within the cable adapter groove and fully seated.

Install the 2 gearshift cable clips.

Fig 4: Gearshift Cable Clips

Courtesy of FORD MOTOR CO.

Connect the gearshift cables to the transaxle gearshift control assembly.
Adjust the gearshift cables. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION AND CLUTCH - GENERAL INFORMATION article.
Install the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
Install the RCM. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM article.