Safety Belt System: Notes

WARNING: All safety belt assemblies including retractors, buckles, front seat belt buckle support assemblies (slide bar), if equipped, shoulder belt height adjusters, if equipped, child safety seat tether bracket assemblies, if equipped, and attaching hardware should be inspected after any collision. Ford recommends new safety belt assemblies be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Safety belt assemblies not in use during a collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted.

The Automatic Locking Retractor (ALR) feature of the safety belt retractor must be checked by a qualified technician to verify that the ALR feature for a child seat is functioning properly, in addition to other checks for proper safety belt system function. A belt and retractor assembly must be replaced if the safety belt assembly's "automatic locking retractor" feature or any other safety belt function is not operating properly when inspected according to the functional inspection procedures in the workshop manual. Failure to replace the belt and retractor assembly could increase the risk of injury in collisions.

WARNING: Each seating position in the vehicle has a specific safety belt assembly which consists of one buckle and one tongue. The safety belt assembly is designed to be used as a pair and is not to be used across seating positions.

WARNING: Never put a rear-facing child seat on the front seat of a vehicle with a passenger airbag. If the airbag deploys, it can hit the back of the child seat with enough force to cause severe personal injury or death to the infant.

WARNING: A forward-facing child safety seat should only be placed in the front seat when it is unavoidable. If you must place a forward facing child seat in the front, always move the seat as far back as possible, because the force of the deploying front passenger air bag could cause death or serious injury to the infant. If the vehicle is equipped with a passenger airbag deactivation switch, the passenger airbag must be deactivated.

When replacing any active occupant restraint components, use only the replacement parts specified in the Ford Customer Service Division Master Parts Catalog.

The active restraint system consists of the following:

Front bucket seat safety belt buckles and pretensioners attached to the inboard side of the seat.
Front row outboard seating position safety belt retractors, located under the B-pillar trim panel.
Second row outboard seating position safety belt retractors, located under the rear quarter trim panel.
Second row center safety belt retractor and RH side safety belt buckle assembly, attached to the RH side of the 20 percent 40/20/40 seat.
Third row safety belt retractors at both seating locations, located under the rear quarter trim panel.
Second row center and LH side safety belt buckle assembly, attached to the LH side of the 20 percent 40/20/40 seat.
Second row RH side safety belt buckle and center safety belt assembly, attached to the floor pan for the 60/40 seat.
Second row center and LH side safety belt buckle assembly, attached to the floor pan for the 60/40 seat.
Third row safety belt buckle assembly for both seating positions, attached to the floor pan.
Second row child safety seat tether anchors, at all three seating positions, attached to the floor pan behind the second row seat.
Third row child safety seat tether anchors, attached to the floor pan behind the third row seat.