Rocker Arm: Installation

WARNING: This page is about a different car, the 2003 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.

Install the rocker arms.
- Position the rocker arms.
- Hand-start the bolts.
- Tighten the bolts in two stages.
  - Stage 1: Tighten to 5 Nm (44 lb-in).
  - Stage 2: Tighten to 32 Nm (24 lb-ft).
    
    Fig 1: Identifying Rocker Arms & Bolt
    Courtesy of FORD MOTOR CO.
Install the valve cover. For additional information, refer to VALVE COVER-RH and VALVE COVER-LH .