Key Programming - Erase All Keys & Program 2 Keys
NOTE:
This procedure is used when a customer needs keys programmed into system and does not have 2 programmed ignition keys available, or when programmed ignition keys have been lost and/or ignition switch assembly has been replaced. This procedure will erase all programmed ignition keys from memory and prevent vehicle from starting until 2 keys have been programmed. Ignition keys must have correct mechanical key cut for vehicle and must be an encoded key. If additional key(s) are to be programmed, perform KEY PROGRAMMING - USING 2 PROGRAMMED KEYS . If remaining keys are with customer and not with vehicle, instruct customer to see owner's manual to program spare key(s).
- Turn ignition switch to LOCK position. Connect Worldwide Diagnostic System (WDS) tester or New Generation Star (NGS) tester to Data Link Connector (DLC). See Fig 1. DLC is located under instrument panel between steering column and radio. See Figure. If WDS or NGS tester is used, insert Ford Service Function (FSF) card VERSION 6.0 or higher. Turn ignition switch to RUN position. Select SERVICE BAY FUNCTIONS and then HEC. Perform KEY PROGRAMMING - SECURITY ACCESS PROCEDURE . After security access procedure has been completed, a new menu will be displayed with command options. Select IGNITION KEY CODE ERASE. DO NOT select any additional commands from this menu, and go to next step.
- Turn ignition switch to LOCK position and disconnect WDS or NGS tester. Insert first encoded ignition key into ignition lock cylinder. Turn ignition switch to RUN position for 3 seconds. Turn ignition switch to LOCK position and remove first encoded key. Go to next step.
- Within 5 seconds, insert second encoded ignition key into ignition lock cylinder. Turn ignition switch to RUN position for 3 seconds. Turn ignition switch to LOCK position and remove second encoded key. Both encoded ignition keys should now start vehicle.