LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2002 >> Mustang Base, 2D Convertible, Standard >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Passive Anti-Theft Systems >> Programming >> Key Programming - Security Access Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Key Programming - Security Access Procedure

NOTE: Security access must be granted to erase ignition keys, enable/disable spare key programming switch, or perform parameter resets for instrument cluster and Powertrain Control Module (PCM). This procedure has a 10 minute time delay prior to granting security access. Worldwide Diagnostic System (WDS) tester or New Generation Star (NGS) tester must remain connected to vehicle. After security access has been granted, security access command menu is displayed which offers various command options. Multiple security access commands can be executed (if necessary) prior to exiting security access command menu. Execution of all necessary security access commands prior to exiting command menu avoids the performance of an additional security access procedure and the associated 10 minute time delay.
  1. Turn ignition switch to LOCK position. Connect Worldwide Diagnostic System (WDS) tester or New Generation Star (NGS) tester to Data Link Connector (DLC). See Figure. DLC is located under instrument panel between steering column and radio. See Figure. If WDS or NGS tester is used, insert Ford Service Function (FSF) card VERSION 6.0 or higher. Turn ignition switch to RUN position. Select FUNCTION TEST MENU, SECURITY ACCESS PROCEDURE. This procedure will take 10 minutes to perform. Go to next step.
  2. After the security access procedure has been completed, a new menu will be displayed with command options. Select as many functions as required before exiting this menu. Once this menu is exited, security access procedure must be performed again to perform additional commands.
scientia non olet · About LEMON Manuals