LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2002 >> Mustang Base, 2D Convertible, Standard >> Repair and Diagnosis >> Body & Frame >> Windows >> Power Window System >> System Tests >> Test H: Right Rear Power Window Inoperative (Convertible)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test H: Right Rear Power Window Inoperative (Convertible)

NOTE: Perform all voltage and resistance tests using a Digital Volt-Ohm Meter (DVOM) with a minimum 10-megohm input impedance, unless stated otherwise in test procedure. Use ohmmeter to isolate wiring harness shorts or opens.
  1. Disconnect right rear window regulator motor 2-pin harness connector C3119. See Figure. Measure resistance between ground and right rear window regulator motor harness connector C3119 terminal No. 1 (Yellow/Black wire). If resistance is more than 5 ohms, go to next step. If resistance is 5 ohms or less, go to step  3.
  2. Disconnect master window/door lock switch 16-pin harness connector C537. See Figure. Measure resistance between right rear window regulator motor harness connector C3119 terminal No. 1 and master window/door lock switch harness connector C537 terminal No. 13 (Yellow/Black wire). If resistance is 5 ohms or less, replace master window/door lock switch. See WINDOW/DOOR LOCK SWITCH  under REMOVAL & INSTALLATION. If resistance is more than 5 ohms, repair open circuit in Yellow/Black wire between right rear window regulator motor and master window/door lock switch. For power windows circuit identification, see WIRING DIAGRAMS . After repair, clear DTCs, repeat self-test and check system for normal operation.
  3. Measure resistance between ground and right rear window regulator motor harness connector C3119 terminal No. 2 (Red/Black wire). If resistance is more than 5 ohms, go to next step. If resistance is 5 ohms or less, go to step  5.
  4. Disconnect master window/door lock switch 16-pin harness connector C537. See Figure. Measure resistance between right rear window regulator motor harness connector C3119 terminal No. 2 and master window/door lock switch harness connector C537 terminal No. 11 (Red/Black wire). If resistance is 5 ohms or less, replace master window/door lock switch. See WINDOW/DOOR LOCK SWITCH  under REMOVAL & INSTALLATION. If resistance is more than 5 ohms, repair open circuit in Red/Black wire between right rear window regulator motor and master window/door lock switch. For power windows circuit identification, see WIRING DIAGRAMS . After repair, clear DTCs, repeat self-test and check system for normal operation.
  5. Test master window/door lock switch. See MASTER WINDOW/DOOR LOCK SWITCH  under COMPONENT TESTS. If switch is okay, replace right rear window regulator motor. See WINDOW REGULATOR MOTOR  under REMOVAL & INSTALLATION. If switch is defective, replace master window/door lock switch. After repair, clear DTCs, repeat self-test and check system for normal operation.
scientia non olet · About LEMON Manuals