Output State Control (OSC) Mode: Notes
Output state control (OSC) allows the technician to control certain transmission function parameters. For example, OSC allows the technician to shift the transmission only when commanding a gear change. If the technician commands 1st gear in OSC, the transmission will remain in 1st gear until the technician commands the next gear. For another example, the technician can command a shift solenoid to turn on or off when carrying out an electrical circuit check. The OSC has two modes of operation for transmission: the BENCH MODE and the DRIVE MODE. Each mode/parameter has a unique set of vehicle operating requirements that the technician must meet before being allowed to operate OSC.
NOTE:
To operate OSC, the digital transmission range (TR) sensor and the vehicle speed sensor (VSS) must be operational. No diagnostic trouble codes (DTCs) related to the digital TR sensor or the VSS can be present.
- The vehicle requirements MUST BE MET when SENDING the OSC value. Refer to vehicle requirements for each individual test.
- If the vehicle requirements are NOT MET when SENDING the OSC value, an ERROR MESSAGE will appear. When the ERROR MESSAGE is received, OSC is aborted and must be restarted.
- If, after a sent value is substituted, the vehicle requirements are no longer met, the PCM will cancel the OSC value and resume normal operation. No error message will be sent.
- The OSC value [XXX] may be sent anytime to cancel OSC.