Removal And Installation
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Make sure that the headlamp switch and the ignition switch are in the OFF position.
- Remove the 5 pin-type retainers and the radiator air deflector.
- Remove the 3 bolts and the headlamp assembly.
- Disconnect the electrical connector.
- To install, tighten to 5 Nm (44 lb-in).
- To install, reverse the removal procedure.
- If necessary, adjust the headlamps. For additional information, refer to Headlamp Adjustment .