Test E: Air Suspension Control Module Does Not Respond To NGS Tester
WARNING: This page is about a different car, the 2002 Lincoln Blackwood. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
After making any repair, perform data link diagnostic test. See DATA LINK DIAGNOSTIC TEST under SELF-DIAGNOSTIC SYSTEM.
- Turn ignition switch to LOCK position. Air suspension control module has two 16-pin connectors. Air suspension control module is located behind center of instrument panel. Disconnect air suspension control module harness connector C2131a. Connector C2131a has blank terminal No. 13. Inspect air suspension control module harness connector C2131a for loose, damaged or corroded terminals. If problem does not exist with harness connector, go to next step. If problem exists with harness connector, repair as necessary.
- Measure resistance in Light Blue/White wire between air suspension control module harness connector C2131a terminal No. 29 and Data Link Connector (DLC) terminal No. 7. See Figure and Fig 1 . If resistance is 5 ohms or less, go to next step. If resistance is more than 5 ohms, repair open in Light Blue/White wire between air suspension control module and DLC.
- Connect air suspension control module harness connector C2131a. Perform data link diagnostic test. See DATA LINK DIAGNOSTIC TEST under SELF-DIAGNOSTIC SYSTEM. If air suspension control module responds to NGS tester, system is functioning properly. If air suspension control module does not respond to NGS tester, replace air suspension control module. See AIR SUSPENSION CONTROL MODULE under REMOVAL & INSTALLATION.