Replacement Of The Weld Nut And Reinforcement

NOTE: The following for Coupe, Front and Rear, and Convertible rear only.

NOTE: If the safety belt anchor nuts or reinforcements are stripped or missing, a new nut/reinforcement plate must be installed

Expose the suspect anchor point.
Drill out two 8 mm (0.32 in) (5/16 inch) diameter access holes adjacent to the weld nut clearance hole.
Thread a length of copper welding wire through the clearance hole and position to secure the weld nut and washer.
Use MIG wire feed welder and plug weld a 7/16 inch weld nut and standard washer in place at the two 8 mm (5/16 inch) holes.
Metal finish as necessary.
Install the restraint system.
Carry out the Functional Test. For additional information, refer to SAFETY BELT SYSTEM .